Answer Posted / j.venkatesan

In case of the numeric relay the negative phase sequence
current is calculated bu NPS=Ir+a2Iy+aIb.
Where a is an 120 degree phase shift opeator.
This calculated NPS is used for operation of the relay.

I need HT sphere gap calibration table. Can any body help me.

1896

---

There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?

2261

---

A 2083kva AVR was tested, phase to ground shows continuity, what is the implications

971

---

What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?

2062

---

which type of cabel

2353

---

What is the difference between electrical earthing and electrical grounding?

1086

---

we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer

1670

---

If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer

2660

---

What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?

1825

---

What is CCT (Correlated Color Temperature) ?

1899

---

how is the connection of a 3 phase ct trivector meter done on a pole mounted transformer

1308

---

can any one tell in easy method for circulating current ??

2062

---

what is saturation kit?which use above 15 kw motors panel side.

4138

---

Define steady state error.

1023

---

how to calculate the capacitor to maintain power factor?

2096

---