Answer Posted / md79

Mr. Venkatesh A.

I have a 347V, 5A continuous NGR.

How can I determine how many ohms of resistor should be
used?

Thank you

sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"

2068

---

Difference between Lugs and Thimbles

15215

---

what is the transformer rush current?

2085

---

What consists of 2 or more thermocouples to be connented series?

2324

---

how to find the torque of the single phase synchronous motor by doing an experiment

1943

---

wat system call?

1977

---

An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%

1937

---

How many double suspension hardware fittings are required on a double circuit transmission tower?

2114

---

What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.

8298

---

Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity

1894

---

Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used

2644

---

if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)

1847

---

What is the BS(British Standard)code for 11kv motor

4993

---

What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)

2169

---

any earth foult trip the relay but in welding time not trip by earth foult

3182

---