How calculate the Transformer Impedence With Example
- 3 Answers
- 5934 Views
- I also Faced
- E-Mail Answers
Answer Posted / viswakumar
% impedance is the voltage required to circulte full load
current in both HV and LV windings when the terminals of
the LV winding is shorted. This is just the SC test done
in the college lab.
For example if 5 % of 11KV circultes full load current in
the both 11KV side and 415 V side of a 11KV/415 volt
transformer then the % impedance of the transformer is 5%
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
When will you multiply and devide with derating factors to the actual value while sizing the cable?
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to reconfirm its base capacity.
How eddy current generation support the idea of train braking?
Difference between On Line capacitor and Station Type capacitor.
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
What are safety device in vcb and acb?
What is clock position of Transformer?what are the clock positions are there?and what is different of them?
Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
Pleae send me last 5 years of Question book about RRB chennai.
Why use in ht motore
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
