Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference between 3 wire and 4 wire RTD sensor?
- 12 Answers
- 43793 Views
- HTA Instrumentation, I also Faced
- E-Mail Answers
Answer Posted / imran aslam
3rd wire is used as compension and if we use 4 wire RTD it
elemeneted more resistence as compere to 3 wire.4 wire is
more perfect
| Is This Answer Correct ? | 41 Yes | 4 No |
Post New Answer View All Answers
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
Senior engineer's please help me, what is Loop Checking and Loop test? and write difference also? soon urgent
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.
give eg of how I/P is used in control loops
What is Positive Calibration and Negative Calibration?
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
how to check earthing,what is minum ohms for proper earthing
why we take %i0.0 as input for twido plc
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
what is cold loop? difference between hot and cold loop?
Explain why use mmwc unit?
TEMPERATURE VARIATION FOR FREQUENTLY.
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
