Interested to Buy Any Domain ? << Click Here >> for more details...
What is the normal value of delta in rotor angle stability
or transient stability?
Why it selected so?
- 1 Answers
- 4153 Views
- I also Faced
- E-Mail Answers
Answer Posted / iamdon
The normal value of delta(load/power/torque angle) is 30
degree.
This is selected so because during power swing (in case of
instability) the flactuation of delta is in the range of +/-
30 degree.This will result the range of delta in 0-60
degree.In this region(0-60)sine curve is linear.
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
I have 440v power coming to facility,( not being used ) can I buy large generator, (gas) to sell power back to electrical co.
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
What is mean 2XWY
how to electrically make connection to ferroli GN2N?
What are the uses of stepper motor?
How to calculate the heat load for a electrical room
Whata are the types of Cables?
Define relative stability.
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
What is the maximum percentage voltage drop (vd%)for a motor control center
What does the a,b,c of 95a,95b,95c relays denotes?
Is there any standard guidelines/Criteria to design NGR/NGT.?
What aturn on methods of scr?
