. Why the transmission lines are in 11kV, 22kV, 33kv, and
why not 10kV,
20kV, 30kV?
Answer Posted / rahul
not clear
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
how we findout a ignater is faulty or not?
What are Contactors? How they works and what its highest rating?
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
how to prepare the technical test
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
How to calculate the heat load for a electrical room
What are linear and non-linear systems?
we use 400/5A ct and 35/roor3KV,/0.1/root3KV,0.1/root3KV pt ratio. What is the multiple factor of this meter.
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
what is mean by ideal infinite bus? why it is required to consider in fault short circuit calculations?
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
would the same effect be achieved by reversing the connection to one winding of the induction motor 3-phase?
WHICH SIZE A.B.CABLE IS USED FOR 11KV.