Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nithi
sorry friends,
The above two answers are correct only for linear loads
(loads which are obeying OHM'S law i.e.V=IR).
But,In general most of the loads are non-linear in nature.
(EX:Induction Motor).
so,current increases both for low voltages & high
voltages which leads to over-heating of the equipment.
| Is This Answer Correct ? | 21 Yes | 4 No |
Post New Answer View All Answers
Who many reason of ignition fail ?
why motor range is available 22kv,30kv,37kv,45kv and so on? why motor range is not available 21kv,24,25,26,27kv and so on?
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
How calculated single phase induction motor req. Capacitor?
How to calculate size of HT breaker with the help of Amp (current)? Please provide answers with examples.
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
3 phase Motor will be given 2 phase after 2 to 5 second we given 3rd phase so Motor Run sum-time in forward or sum time run reverse direction. All time phase sequence is not change. Why motor run in reverse direction? Please Explain........
Show the schematic arrangement of diesel power station layout and give its principle of operation.
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
v/f drive basic princeple
Explain the operation carried out in thermal power stations?
PLZ EXPLAIN CORONA,SKIN,BIRD PALE,SPAN,SAG Effects of power cable.
what is meant by surge? what we called for high currents?
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
