Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen if we give a dc supply to a transformer.?
- 10 Answers
- 20213 Views
- I also Faced
- E-Mail Answers
Answer Posted / mayilsamy ranganathan
When Dc supply is given to primary of transformer it draws
heavy current from the DC source due to absence of back emf
and burnt out.Because the dc current not varying with time
it has constant value throught the period.
(AC is given to transformer the sinusoidaly varying
current creates a sinusoidaly varying flux ,this flux cuts
the stationary primary coils and creats a back emf,
(statically induced emf)this back emf opposes the applied
voltage source to drive current(Lenz law) so current is
limited by this back emf hence no overdrawal of current
from source,this is not happen while applying dc)
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
In 90 kva alternator that produce the output voltage is 115(p-n),200(p-p) at 1500 rpms means what ampere it produced ?
Whether power factor should be high or low? Why?
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
What is the control action?
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
How to design pavement quality concrete by using C.R.C.P Method
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
PLEASE TELL ME ABOUT QUESTION PAPER OF UPCL ENTERENCE EXAM.
what is the voltage between earth to neutral in lift.
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
the typical output of a solar cell is........
how choose conductor&depending upon load
What is creepage distance..... what will be the value for different voltage level
How to apply 'c' license and also explain what is difference between 'c' and 'b'license.i am also working in one of the private company.i have finished my diploma in 2014 .i have already finished in ITI electrician course.....
we specify current in case of feeder but in case of distributor voltage, why?
