Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen if we give a dc supply to a transformer.?
- 10 Answers
- 20230 Views
- I also Faced
- E-Mail Answers
Answer Posted / sonam
for the first time when u give DC to transformer u will get some volt at the o/p for few seconds, after that no volt is transferred to secondary as because of the explanation give above
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
what does mean of RCT and STR in diffrential CT?
what is transient stability analysis means?
What is float cum boost charging system?
What kind of socket shall be provided for window type air conditioner with cooling capacity upto 18000 BTU/hr
distribution transformer de-rating formula on over limit iron losses
define the non synchoronism of synchoronous machine in general g or m??
Define branch?
explain single phase series motor
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
What is the difference between electrical earthing and electrical grounding?
how i can calculate the size for fire cable
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
