Answer Posted / irshad

A Standard can be defined as a set of technical definitions and guidelines that
function as instructions for designers, manufacturers, operators, or users of
equipment.


A standard becomes a Code when it has been adopted by one or more
governmental bodies and is enforceable by law, or when it has been incorporated
into a business contract.

What is a slined joint?

1057

---

What type of pump is are commonly used in auxiliary boilers?

1937

---

What will be the cause of the loose compression in a cylinder?

3219

---

workingh principle of valve timing chart for cummins engine

2607

---

What the function of bye pass filter in DG.

1762

---

If I can absorb 9,000 lux of sunlight in the bottom of a pool what will the temp rise be per hour, per square foot of absorbing material, per gallon be? Temp of pool deck 115 degrees, water temp 75 degrees, 120,000 lux on the pool deck

2130

---

diffuser increases pressure but in turbine pressure is decreasing when steam passing through casing?

3653

---

Is your basic salary of $...... , good for you if employed?In case of any eventuailt,who is your next of kin?

1605

---

Between steel, copper and brass, which conduct faster heat.

1105

---

Which impurities form hard scale and which impurities soft scale ?

1093

---

I WORKED AS A Q.C INSPECTOR IN STATIC EQUIPMENT.WHAT ARE THE QUESTIONS ARE LIKELY TO BE ASKED IN AN INTERVIEW.

9787

---

Does the rate increase by experience or number of years worked?

1039

---

Difference between turbocharging and supercharging in diesel engines?

1488

---

How will you create a piston head?

1173

---

How is the gear ratio calculated?

1117

---