As per the theory current doesn’t flows in Neutral, but
practically it is
not applicable, explain why?
Answer Posted / shariff
If the all the three phase have equal loading them In=0, but in practical , the phase loading will differ, hence the differ current fill flow in neutral.
Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
working function importance of mdc meter
If two Transformers are connected in parallel having impedance of 50KA in both transformers will the impedance increase or decrease after connecting transformers in parallel?
Why efficiency of generator is higher than motor at a particular load?
what are the main faults that occur in stabilizers? How they corrected and resolved ? Types of stabilizers ?
How to calculate the sag on transmission Lines.
if we have 320KVA Genset kindly advice how much load we can put it.
How Can you do Maintenance of ACB of 2000Amperes
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
USE OF 8 WAY PAN ASSEMBLY
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
WHAT IS ELECTRICAL MAINTAINTENCE ?
how the inner and outer body is separated in aircrafts?