Interested to Buy Any Domain ? << Click Here >> for more details...
21. What is the purpose of taking Capacitance and Tan Delta
Test in
Transformer bushing?
22. What are the protections to be used for Generator?
23. Draw the vector diagram and condition for the
following: 1) Dyn1
2) Ynd0 3) YnYn0
24. What happens when the polarity changes in CT? Explain
briefly?
25. Explain the Term in CT Name Plate – Class: 5P10
- 3 Answers
- 9491 Views
- I also Faced
- E-Mail Answers
Answer Posted / naresh
Pole slipping,backup protection,differential,dead machine
protection,low forward power,voltage control over
current,current control over voltage,df/dt,if ct polarity
chenge in protection reverse active power flows to relay
and diff current flow and in metering import power wil show
in energy meter,for five times of primary current 10%
composite error.
| Is This Answer Correct ? | 0 Yes | 7 No |
Post New Answer View All Answers
explain with diagram how to protect transformers and substations from over current with help of CT's?
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
what is thermal resistance of PVC Cable.
ht side line to earth voltage
how single phase preventer works ?
What Maximam Gap Taibaar & Bush
What is the selection process of breakers. Can any one please give a formulation on same?
Where can i get practical knowledge of solar system?
can you plz send l&t aptitude questions if available its urgent plz plz plz
What is the working principle of CFL & T5 tube light & 40W tube light with electronic ballast?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
Why air circuit breaker off due to power failure?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
