what is the full form of XLPE adn there use.
- 4 Answers
- 29068 Views
- Voltas, I also Faced
- E-Mail Answers
Answer Posted / dinesh lokhande
XLPE comes from the term cross linked polyethylene.
Crosslinked polyethlene, which results from a chemical
process of “cross-linking” of the molecular structure, has
eliminated defect of melting point 110ºC..
The features of cross-linked polyethylene
are as mentioned below in brief.
(1) High softening temperature and small heat distortion
(2) High mechanical strength under high temperature.
(3) Superior heat aging resistance.
(4) High resistance against stress cracking.
(5) Superior electrical characteristics.
(6) Light in weight.
| Is This Answer Correct ? | 55 Yes | 4 No |
Post New Answer View All Answers
operation of protection relay watchdog contact?
working principle of oil startar
what's prime importance of protection in electrical system.if protection system don't work properly what can happen in electrical system?
how to failure indution motor insulation & how to improve heat in motor insulation
I AM FROM ELECTRICAL ENGINEERING ? I AM ASPIRING FOR "BHEL".HOW I HAVE TO PREPARE .ON WHICH TOPICS TO BE CONCENTRATE MORE.PLEASE GIVE FULL DETAILS OF WRITTEN EXAM.
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
how to calculate maximum current
How to calculate multiplication factor in kva example 500kva ans pls ?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
how to calculate the size of the HT cable
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
What is reverse power relay?
What is the difference between UPS & inverter ? which UPS is better and whos got the edge ? what is the difference between & inverter ? which UPS is better and whos got the edge 12 V , 24 V , 36 V etc what are the advantages of 12 V, 24 V , 36 V etc and what are the disadvantages of 12 V, 24 V, 36 V etc thanks
What do you mean by Frame 5 Gas Turbine as well as Mark II.
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
