Answer Posted / kumar
because there is no need for extra neutral connection and
the current consumption is less compared to star connection
and also initial current and torque is high.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
Define non-touching loop.
What is the efficiency during maximum power transfer?
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
what's prime importance of protection in electrical system.if protection system don't work properly what can happen in electrical system?
how to control the speed to switched reluctance motor
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
Which device is used for the source of emission of electrons in a crt?
What is relation between mu(nought) and epsilon(nought)?
what is JE exam?
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?
what the principle of sincroscope?how it works?when it needed?
What is DC series motor?
How to calculate the sag on transmission Lines.
