Interested to Buy Any Domain ? << Click Here >> for more details...
what is different between modbus and serial link?
please could anybody give right answer.
- 2 Answers
- 6938 Views
- I also Faced
- E-Mail Answers
Answer Posted / nitin
Modbus allows for communication between many devices
connected to the same network, for example a system that
measures temperature and humidity and communicates the
results to a computer. Modbus is often used to connect a
supervisory computer with a remote terminal unit (RTU) in
supervisory control and data acquisition (SCADA) systems.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
why we use cascade control and feed forward control in 3 element drum level control measurement of steam drum .what is cascade and feed forward control system ?give example .
Sir, I am working as a Instrument Engineer in Grasim Industries. Can any body provide question answer for interview purpose
How does your previous experience relate to the job you are applying for ?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
List three types Level Gauges with their working principles
Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?
Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
what does it mean an active front end in vfd plz explain it briefly
how many type conductivity sensor ?
what is instrument philosophy
