what is the differnce between vector and phasor? are both
same or there is difference between two term.?
Answer Posted / b.vivek
both are same
Is This Answer Correct ? | 2 Yes | 25 No |
Post New Answer View All Answers
how can i reduce sparking without stepdowning the voltage
How to calculate earth fault current for 6.6 KV , 50 HZ , 756 Amps , 3000 RPM , 0.8 PF generator
what is physical distance of isolator to VCB in 33/11kv sub stations
how we select ac fuse rating of an power inverter???
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
What is Load sharing of Transformer ?
what will be the maximum winding temperature of 6.6kv HT motor 450kw, Full load current 49A. 50Hz Frequency.
The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is
Dear Sir I am living in Jaipur Rajasthan now I did complete my b tech degree in electrical engineering in 2012 Sir how I gate certificate of competency for electrical supervisor
What is the exact formula for one weber of magnetic flux?
How can we checked Killo Watts of Motor & Alternator?
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
How PADO software increase the efficiency of power plant?
what is servo motor and how to work it.
what is the ms flat constant for calculating earth mat design calculation?