What are the circuit models used for analysis of medium
length transmission lines? Which one is superior? Support
your answer.
- 1 Answers
- 5125 Views
- UPSC, I also Faced
- E-Mail Answers
Answer Posted / iamdon
The medium length transmission lines are analysed with the
help of two models...
1)Nominal pie model
2)Nominal T model.
Out of these two models,Nominal pie model is superior in
following terms..
1)In the case of Nominal T model, an extra node is
introduced at the T junction,which increases the order of
system by 1.Increase in order of a system is never desired
as it complicates the control analysis particularly.Nominal
pie model doesn't alter the order of system.
2)In case of Nominal pie model,all shunt parameters
appearing at load end and sending end can be respictively
added to get the equivalent.This simplify the calculation.
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
What is meant by Low Resistance Cable and High Resistance Cable.
Why is the starting current high in dc motor?
What are the basic component of a cro?
what is alluminium arm in ab conductors
what is meant by impedance & transient protection?
How Calculet The UPS AH In Load
for what purpose the star point is done in ct
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
can i able to get bhel previous exam question paper?
what is the basic need of domestic loads 1- voltage 2- current
