What is the difference between electric and electronic circuits?
- 11 Answers
- 24690 Views
- I also Faced
- E-Mail Answers
Answer Posted / arnaldo valencia
Electric ckt are composed of hard wiring components like
motor starters eg. Star-delta, start-stop,and any reduce
voltage and reduce current motor starters.We can consider
the house wiring as elctric ircuits too, because those two
examples are using a minimum voltage of 24volts up to 440
or higher.
Electronics circuits are compose of a semi conductor
components like resistors, diodes,transistors printed
circuit boards and other semi conductors components.We can
call electronics circuit as a very sofisticated circuit
that can be used for controlling the motors speed,output
voltage and output currents and it always uses small
voltages for there coponents.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
what is star delta starter? how it works? give its control and power diagram.
Mention the difference between Analogue and Digital circuit?
How to decide and select the different earthing wire size for the different types of earthing
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
How can we select suitable capacity generator for three phase load (inductive load) and how to take study analysis in 3 three phase load system ?
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
what is the id1 & id2 setting in differential protection relay of CSPC?
Sir, My doubt on cable sizing calculation, Load:74 KW calculated cable 1 run 50mm2. Now client asking us to reduce cable size by increasing runs. Sir, My question now when my mind strikes with 2 options 1) Divide load 74/2 = 36 and calculate cable for 36+36 making it 2 runs or 2) Simply i can divide 50mm2 /2 ie. 2 runs of 25mm2 Please suggest me sir
PLZ EXPLIN ABOUT CLASS PS CLASS CT .WHY THEY R DESINED AND FOR WHAT PURPOSE?WHY OTHER CT CANT BE USED AS PS CLASS CT? EXPLAIN IN SIMPLE LAUNGAGE IF POSSIBLE PLZ GIVE CIRCIT DIAGRAM?EMAIL-RAJ_SINGH_0376@SIFY.COM
why occ characteristics of generator is also called as magnatization characteristics ?
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
what should be the no load current for 3 phase ac motors ranging from 5 kw to 1000kw?
what purpose to use excaiter in DG.?
Maintenance of transformer???
700KW 6.6KV slip ring induction motor to use VFD to control the speed
