Why all voltage levels are the multiples of 11KV?
Answer Posted / shariff
It is just the standard being maintained by all the transmission utilities, with form factor 1.11, voltage not even multiple of 11 is being under use, like 132kV,400kV etc, if this old standard is changed then it should be changed all over, from generating to distribution level, which is not possible in practical, hence the same std being maintained.
Is This Answer Correct ? | 4 Yes | 11 No |
Post New Answer View All Answers
How can get elongation of 2 k.G aluminium, if elongated aluminium dia is 2.5 mm?
how to modify DOL control panel into Delta Y connection?
what is rocking arrangement in arc heating
What is the previous name of Cox's Bazar
What will be result if we connect LT votage to the terminal of HT motor?
what is the difference between capacitive and resistive voltage divider?
Single line diagram for dbb (double bus bar)system.
Differentiate between voltage and current feedback in amplifiers?
what are the necessary basic electrical topics to learn for mechanical engineer to deal practical problems.
What is dielectric loss?
what is the ms flat constant for calculating earth mat design calculation?
In CTs tan delta point should be earthed , what is the reason behind it?
orifice sizing how done, checking & selection
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
why impedance relay is used for medium transmission line protection