Interested to Buy Any Domain ? << Click Here >> for more details...
While connecting bulb in Series/Parallel,there is any
difference in glowing
- 3 Answers
- 6236 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajeshsan
Yes there is difference.
1. While connecting the bulb in series the voltage drop between the circuit will be V1+V2, considering V as supply. It is like connecting two resistor in series.
2. But while connecting the bulb in parallel, the voltage across the each bulb are equal. say V1=V2=V.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
give single line diagram of D.G distribution form alternator to main L.T panel?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
How to select a cable size for particular load?
HOW WORK HEAT PLATE EXCHANGER
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
what is the purpose of high speed earth switch in gas insulated substat
how to find three phase complex power in per unit and MVA?
plese send me the oces/dgfs sylabus and previous year question pattern of electrical engg.?
is there any current and voltage drop on liquid resistance starter water/soda tank ?
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
How is the connection of the tap changer on the HV side been made?
Why do we perform an open-circuit test and short-circuit test on the transformer?
What is current & voltage ? Voltage perform at any load without current or not?
