Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rajeshsan
The loads can be classified as based on
1. Continuous load and intermediate load.
2. Static and Dynamic load
3. Load may be inductive or capacitive.
| Is This Answer Correct ? | 4 Yes | 11 No |
Post New Answer View All Answers
hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E
Why the output of OP-AMP is always less than Vcc?
how to calculate slip ring induction motor stator and rotor currents??
how many synchronous motor are there in any power plant
How to calculate capacitor bank size at a load 800kVA.
Which level of the Transformer oil got dielectric strengh? And why?
what is package substation.how many types they have
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
why should the lowest unit of a testing transformer ( cascaded transformer ) have higher power rating??
DG cranking voltage?
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
What is oscillator circuit?
How much earthing frequency is capable?
how the testing of protection CT Testing done through Primary injection kit please describe in detail procedure...
