Answer Posted / rajeshsan

salient pole machines driven by water turbines at a speed in the range 50 ±1000 rev/min. Generally used for low speed applications. The speed depends on the type of turbine,which in turn depends on the head and the flow rate of the water available. At low speeds, the permissible rotor diameter will be several times its active length. Generally,the largest allowable diameter of rotor is used to maximise the machine's inertia which is an important part of overing the water turbine. Outputs up to 800MW have been achieved. A small high-speed unit will have a horizontal shaft, but for reasons of mechanical construction and stability larger machines have vertical shafts.

Define non-touching loop.

1322

---

If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.

1088

---

What is the instrument to check the rotating diode fuse of alternator in running conditions?

2467

---

How can two 3 phase transformers of same KVA and Voltage be connected in parallel?

1886

---

why to use freewheeling diode ( diode in revers bias mode) across dc coil

5011

---

How can maintain our H.T. motors used in cement plant. please send me procedure.

5146

---

Define closed loop control system.

1079

---

how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?

1723

---

testing of Vector Group – YNaoD II

2925

---

what is the major difference between LIBBP & HIBBP.. which one is most preferable..

2971

---

What is the Diff. btw Manule Pull Station & Manule Abort Station Switches used in FM200 System??

1853

---

How to perform a DC resistance test In Alternator and their proceduces?

1752

---

WHAT IS THE DIFFERENCE BETWEEN GENERAL INVERTER AND SOLOR INVERTER TELL ME PLZ

2209

---

what happen ehen synchronisation is done at below rated speed

2139

---

How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?

1074

---