Interested to Buy Any Domain ? << Click Here >> for more details...
What is an Isolation Xformer? What is the use of it?
- 2 Answers
- 8145 Views
- I also Faced
- E-Mail Answers
Answer Posted / iamdon
As name suggest Isolation transformer does not alter
power,voltage or current level.It only electrically isolate
two parts of circuits.It has turn ratio of 1:1
It is use in amplifier circuit.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.
What Should be the value of Vector Surge angle at Tripping and how to calculate it?
can we use trip light with bus coupler?
what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).
WHAT CAUSED THRESHOLD VOLTAGE TO EXIST?
draw singleline diagram of star to delta and dol starters
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
How line capacitance & line inductance varies with increase in height tower.
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
What is the role of feedback in a closed loop control system?
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
