why we are having many type of vector group in the
transformer ,what is the use of it?
Answer Posted / iamdon
Vector group arises due to relative diference between
primary and secondary windings of the transformer.Since
each of such windings has some advantage over other so we
use all of them in particular apppliction.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to check three phase motor torque value?
What is the high series capacitance winding on high voltage power transformer ?
how to calculate slip ring induction motor stator and rotor currents??
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
Can you explain about Restricited earth fault protection scheme
what is x'mer ,isolation x'mer & yltra-isolation x'mer?????
WHAT IS THE FORMULA FOR CALCULATING CURRENT RATING(DIRECT IN GROUND OR AIR) OF ARMOURED(XLPE) CABLE OF 4C,16Sqmm?
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
what is difference between cpp electrical system and refinery electrical system
in our all power plant have connected in grid and grid voltage and plant voltage is same, but as per as electrical concept the power will transmit from high potential to low potential but here altough same,then how power transmit from power plant to grid.
tell me about eletrical contractor
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
ACB & VCB how do work and saftes and how can maintenance in this and parts name show with picture
What is a single phase autotransformer?