Interested to Buy Any Domain ? << Click Here >> for more details...
Waht will happened if reactive power increase in the line?
waht about active power increase too?
- 3 Answers
- 10440 Views
- I also Faced
- E-Mail Answers
Answer Posted / iamdon
Reactive power flows from higher voltage to lower
voltage.Flow of increased reactive power in line
causes power factor to reduce.For fixed value of
sending end voltage, receiving end voltage drops.
Active power flows from side which has leading
voltage angle to lagging end.
Increased Active power flow causes more line losses.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is the difference between a verilog task and a verilog function?
what is cascade speed control device?and how this device control the speed of motors?
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
why fractional pitch winding generally used in alternators?
How to calculate the fuse rating depend upon the DC circuit?
Why increase in current leads to increase in conductor temperature?
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
limitation of conductor height on ground when we consider EMC
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
75 kw motor take 45 amp in no load delta in star 10 amp but in load it will take 160 amp but IR velue of winding above 500 at 1kw ph to earth and ph to ph. what problem it should be?
How much no load current of synchronous motor
For a spring controlled governer the relation F = ar+b (F is the controlling force, r is the radius of rotation a and b are constants), indicates that the governer is
How equivalent impedance is calculated in thevenin theorem?
