What are the fire Estingushers use in electrical fire?
- 3 Answers
- 4932 Views
- I also Faced
- E-Mail Answers
Answer Posted / s.venkatesh
Fire Extingusher B and C type will use in wherever
electrical fire accident happend,Because that two types
only having fleroside quenching type of cabability material
was contain while manufacturing
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is the end effect of linear induction motor ??
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
What is the difference between earthing,ground&nutral?
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
from where the self excitrd induction generator get the power?why is the voltage regulation is poor of seig?
What is icu and ics in Acb and how many time icu or ics passes from breaker?
what will be d.g. capacity to cater together for 14hp A.C. load & 3kw lighting load
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
what is the Earth Voltages in Power Plants, Sub-stations, Industries, Residential & Commercial Buildings.
Let me know that how i calculate the alternator sub tranciant reactance and tranciant reactance.
Differentiate between low pass, high pass and band pass filter?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
