why transformer ratings in kva?
Answer Posted / manikanta..{munna} geethanjali
load is something which dissipates energy..!! in case of
transformer , ideally a transformer is power source
device...and but this acts as load practically bcoz of
losses in it...!!!
coming 2 d rating any load is alwayz rated in kw..!! here
in a transformer the losses are due 2 copper and iron which
depend on current and voltage respectively...there fore v
rate the transformer in v*i !!!! and they is no use of
including powerfactor.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is doid
What is Instantaneous Earth fault relay,how will work
Please explain me about Relay curves and their sources to read ?
What are the advantages of the three-phase motor over single phase motor?
How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
what is meant by directional earth fault and non directional earth fault? describe both.
I want to know all basics of electrical engineering
how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?
how the B-H loop obtain under the static condition
I want to know Electrical Circuit?
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
what is the importance of earthing system on the generators big capacity and small?
Can you explain about pole discrepancy scheme