Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / prateek jha
Flow Rate is usually used in industries working on
hydraulic and pneumatic areas to specify the amount of
working fluid passed across a fixed cross-section areas in
fixed time. Mostly, we describe flow rate in Litre Per
Minute means how much litres of working fluid has been
passed through a given cross-section area in One minute.
Flow Rate is independent of pressure in
hydraulic i.e liquid. but is dependent on pressure in gases
as gases are compressible at pressure. Hydraulic is also
compressible but at higher pressure.
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
Explain an adaptive / self-tuning controller’s major draw card.
Speedtronic system .
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
What is instrumentation technologists and mechanics?
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
why we are not using the turbine flow meter in the steam service?
What is zener diode? What is voltage regulator?
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
Explain Gas Turbine startup and shutdown sequences
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
How digital input and digital output 's are working in dcs
If we increase only P what will be controller action ?
In Safe Guarding test what means by "Failed to Danger" ?
What are the uses of orifice plates?
dear sir we have insatlled positioner model no.sipart PS2 make Siemens at our control valves . now problem is if we want to increase the response of valve opening speedy /fast. what parameters do we change for positioner ? any idea. please guide us.
