In a Synchronous generator, Can AC voltage be used instead
of DC voltage in field winding of rotor to produce AC power?
- 10 Answers
- 17183 Views
- NTPC, Windia, I also Faced
- E-Mail Answers
Answer Posted / rajasekhar
we cant use ac voltage in place of dc for exitation of field
winding because for every cycle the polarity of the field
winding will be changing so there will not be constant poles
on the rotor
| Is This Answer Correct ? | 15 Yes | 1 No |
Post New Answer View All Answers
After completing iti in electrician, how can i get certificate of electrical supervisor? What ia requirements. For it?
sir i completed apprentice in TNEB.apprentice is eligible for 'c' licence
For group 1 , 2 whather i have to prepare my technical or general studies etc? and im graduate in ee engg. for wht posts im eligible for? please tell me!
what is meant by power and distribution transformer ?
What is “pu” in ee?
Why is negative feedback invariably preferred in closed loop system?
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
What is the working principle of servo motor? And explain it.
how calculate gd2 of ht motors
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
What is the ratio of true power to apparent power in an ac circuit?
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what is the minimum voltage require to injure our body?
