when we are going to higher voltage level in substations why
we are using Sf6 circuit breakers instead of Vacuum circuit
breakers.
- 3 Answers
- 4730 Views
- I also Faced
- E-Mail Answers
Answer Posted / vinod
SF6 CKT BREAKERS ARE ELECTRONEGATIVE THEY ABSORB FREE
ELECTRONS PRESENT AROUND CONDUTORS,AVOIDING BREAKDOWN.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
how to calculate the earth mat design in 132 kv substation yard ????
Different types of relay fault which phase sequence??
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
How phase to phase voltage comes 440V.
What is the limitation of kirchoffs law?
Difference between control junction box (cjb) and power junction box(pjb)?
application s to shunt coil
what is meant by twilight switches 7 where its applicable ?
Define the three phase formula fuse.
how r charge carriers produced
How to calculate the sag on transmission Lines.
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
Advantages of using generator circuit breaker (GCB) scheme in a power station ?
