Interested to Buy Any Domain ? << Click Here >> for more details...
what is different between IP55,IP54 and IP66?
- 2 Answers
- 56809 Views
- ABB, Global Industries, I also Faced
- E-Mail Answers
Answer Posted / milind parashar
Ingress Protection Rating consists of the letters IP
followed by two digits and an optional letter.It classifies
the degrees of protection provided against the intrusion of
solid objects (including body parts like hands and
fingers), dust, accidental contact, and water in electrical
enclosures
IP55-(5)dust protected,(5)Water projected by a nozzle
against enclosure from any direction shall have no harmful
effects
IP54-(5)dust protected,(4)Water splashing against the
enclosure from any direction shall have no harmful effect
IP66-(6)dust tight,(6)powerful water jets
| Is This Answer Correct ? | 89 Yes | 5 No |
Post New Answer View All Answers
why need to be maintain power factor for industrial customer?
i want to know that how the height of Ct ,cvt ,LA calculated on the basis of creepage distance
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
how desiel generate sart fail of eb?
how to calculate the torque of a motor?
What are n circles?
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
Can anyone please provide me details of MCCB/Contactor/SFU rating calculations for a motor feeder..for example 50 kw.. not from type-2 cordination chart. i want manual calculations..
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor
how to erect roof control panel?
which protection used in power plant?
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter
When the relative speed between the magnetic fields of stator and rotor does is zero under steady state operation?
What is ST and specify its range of voltage.
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
