Interested to Buy Any Domain ? << Click Here >> for more details...
what is the basic working principle of I/P and Positioner in
any control valve.
- 12 Answers
- 80967 Views
- Essar, Visa Steel, I also Faced
- E-Mail Answers
Answer Posted / ashok polampalli
I/P Converter , converts 4-20 mA signal from controller
to .2 to 1.0 Kg/cm2 pneumatic signal.
Positioner consist of air supply port , signal input port,
out put port.When positioner get in put signal ,it compare
with stem position and output is generated and signal
boosted sufficiently to operate the valve . It uses force
balance system.
| Is This Answer Correct ? | 73 Yes | 15 No |
Post New Answer View All Answers
what is the responsibility of an instrument commissioning supervisor
Draw a great bridge circuit.
what is The specifications for oriface instalation
How is PH sensor works ?
Which topics are covered in Process Control?
Hi Friends i am going to write BARC written test by this month 20th (20-5-2008). So please if any body knows the details about this or having previous question papers pls mail me to kkumarei@gmail.com. For Suggestions give one message to 9962122264
What is difference between Ionization heat and bimetallic heat
Define cryogenic?
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
can you send remote seal interface level transmitter calculation steps for oil water saperator.
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
what is IEC code in cables & how to selecting cables?
Programmable Logic control.
send me HPCL paper
What is frequency factor in massflow meter? When using frequency output?
