Interested to Buy Any Domain ? << Click Here >> for more details...
What is difference between PVC cable & XLPE cable?
- 14 Answers
- 198278 Views
- Intertek, I also Faced
- E-Mail Answers
Answer Posted / minal verma
Pvc cable is used for less than 450 v , while XLPE is used
for voltages above 500 v.
Pvc cable is also called LT cable while XLPE is HT cable.
| Is This Answer Correct ? | 23 Yes | 83 No |
Post New Answer View All Answers
HOW THE OLTC TRANSFORMER SAVE ENERGY IN COMPARISON TO OFF LINE TRANSFORMER AND IS IT ECONOMICAL TO REPLACE THE OFF LINE TRANSFORMER TO OLTC TRANSFORMER
What are high pass filter and low pass filter? and What are the flowmeter ?
WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.
why ct ,cvt should be stored in a vertical position?
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
why dc is used in control circuits for MV & LV switchgeras instead of ac
How much load can take a 16 mm aluminum cable 3 phase
hi friends ,iam working as genset AVR service engineer in electrical field from past 2 yrs throughout india . i plan to shift in some other job without travelling in same field because i con't travel,i dont know what i do for that so please guide me what job is suited for me,how i can serch the job please anybody helpme iam totally confused
What are the no-load losses for the 11000/415V transformer with the following rated capacity? 1.1500 kVA 2. 2000 kVA 3. 2500 kVA 4. 3000 kVA
what is the difference between an alternator and a synchronous motor
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
give me a clear defination of inductance,and how can u calculate inductance of a motor
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
Why does the radius of armature is less than the radius of pole shoe?
