Interested to Buy Any Domain ? << Click Here >> for more details...
how the slump and Compressive Strength of concrete cube is
performed in a civil engg lab ?
- 8 Answers
- 27610 Views
- Lodha, SSC, I also Faced
- E-Mail Answers
Answer Posted / patricio baluga jr
Fill up the whole cone up to the top with some excess
concrete coming out of top, then repeat tamping 25 times.
(if there is not enough concrete from tamping compression,
stop tamping, add more, then continue tamping at previous
number)
Remove excess concrete from the opening of the slump cone
by using tamping rod in a rolling motion until flat.
Slowly and carefully remove the cone by lifting it
vertically (5 seconds +/- 2 seconds), making sure that the
concrete sample does not move.
Wait for the concrete mixture as it slowly slumps.
After the concrete stabilizes, measure the slump-height by
turning the slump cone upside down next to the sample,
placing the tamping rod on the slump cone and measuring the
distance from the rod to the ORIGINAL DISPLACED CENTER.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is soil enforcement?
What is the difference between Hinged and pinned in Column ends
What is the life of anaerobic Digester if it is used for municipal solid waste digetion.
What is an ortho mode?
what is stressing
What is rate for brick masonry work of 1.0 m3 in cm 1:6?
What in your past experience or education prepares you for the position for which you are applying
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
punj loyed and sapurjl palanjl
What are the strongest shapes in building?
I have completed building maintenance course in mcvc stream .. can I apply for the post of " sthapstya abhiyantriki sahayyak"?
IN Compression testing machine 1division =10KN ,then what is compressive strength of 100*100 mm cubes at a load of 320 KN
What is the frequency of sampling for the materials of cement,Fine aggregate, Coarse aggregate .and refer which code
how to calculate the chair reinforcement length in slabs, footing or anywhere??
What Reinforcements Are Used In The Process Of Prestressing?
