Interested to Buy Any Domain ? << Click Here >> for more details...
i have one absolute pressure transmitter for the range is
-400mmhg to 400mmhg. If i do the zero trim at atmosphere the
transmitter should be give 4ma or 12ma? which one is correct?
- 2 Answers
- 8084 Views
- I also Faced
- E-Mail Answers
Answer Posted / senthil.doosan
-400mmhg= -0.53bar
400mmhg = +0.53bar
if u do zero trim by opening the valves with respect to atm
the output of the transmitter is 12ma
without any process connection the output is 4ma
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
How do bending tubing provide better measurement than using tubing fittings such as elbows?
State bernoulli’s application.
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
How the sizing of the analog signal cable is calculate?
why fuse block is not used for AI signal?
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
HI friends.I am Surya a BTech in Electronics and Instrumentation Engineering.I am going to appear Relince Industries Ltd all India writen test very soon. so plz help me by sendind the probable questions about my subject.My mail ID is surya.barik@gmail.com.
What is the start up procedure of desalter
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
Galvanizing.
what are procedure of sox-nox calibration
