Interested to Buy Any Domain ? << Click Here >> for more details...
if in centrifugel pump suction,discharge and impeller size
constant and motor rpm increase.what is the effect on
pressure and flow.
- 7 Answers
- 12650 Views
- ITC Infotech, PCBL, I also Faced
- E-Mail Answers
Answer Posted / karthick
both pressure and flow increases but the efficiency decreases
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Explain how is a submarine able to submerge and surface?
What do you understand by the hooke`s coupling. What are its purposes?
I heard that the acetylene cylinder pressure can't be brought down below bar while using for welding activity. Is it true. . If so pl explain why
Dear sir-I WANT LAST FIVE YEARS RRB-CHENNAI QUESTION&ANSWER PAPER IN J.ENGG(GRADE:II)-MECHANICAL ENGINEER
what is composition for cast iron as per is 120 grade 25
As compression ratio increases, thermal n increases. How is thermal n affected by weak and rich mixture strength ?
What is the difference between a mechanical engineer & a Marine engneer?
Is IS 2062 different from ASTM A 36 or both are almost same
Assume a DC motor with the following parameters : Motor torque control = 0.0848 Nm/amperes Back EMF control = 0.0848 Volts/(rad/s) Armature resistance = 0.75 Moment of inertia = 0.00001696 kg/m2 With zero frictional load and taking a feed forward gain of 2, determine the motor response for a unit step function. please forwaded the answer to the below mail id thanks in advance Regrads, peer_kaba@yahoo.co.in
what is the minimum velocity of cooling water for maximum efficiency of condensor.
What type of pump is main L.O. pump?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What do you mean by KG and KGS in Diesel Engine
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
Is there a metal that does not contain iron?
