Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ajit
it is a protective zone relay it sence the vector
difference between two or more similar quantities.
generally it is current operated .at normal operating time
the sum of Ia+Ib+Ic=0 ,but in abnormal conditation the
resultant current will not zero some current will flow
through trip coil & trip the circuit. most differential
relays are baised current differential current.
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
What is nyquist contour?
IN electrical field, WHAT ALL THINGS THE CUSTOMER WILL ASK WHILE ORDERING FOR LT PANEL (ALL TYPES OF LOW TENSION PANEL)
What is the classification of hydro projects based on installed capacity?
When we giving the 3 phase supply to ups system how to coming netural?
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
Who many reason of ignition fail ?
how to calculate the surge level of surge suppressors related to the SF6 cicuit breakers?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
Why is tan-delta test and capacitor measurement done on alternator?
Can any body tell gulf interview question for experienced electrical engineer ?
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
how to design coil turns ?
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
what is circuit breaker in transfomer and where it used
