Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ch jaya murali
We are Manufactured the same panels. the panel principal is when the mains fails is there that time the microprocessor is detected mains are fail. After the supervising the mains the amf controller is give the sense to crank. And When the Ingen is run the controller is supervise the alternator supply. That supply is present and healthy, the dg cont actor sence is given to dg cont actor. that mount the dg supply is present in out put terminal. when the mains present that monument mains supply is healthy that time dg supply is break the microprocessor and give the mains supply. After the cooling time the dg is stop sence is given to stop solenoid.than the in gen is stopped.
| Is This Answer Correct ? | 35 Yes | 8 No |
Post New Answer View All Answers
why zero sequence impedance measurement is not applicable for single phase GT
Why power factor should not be in leading (capacitive) mode of any load.
how i chosse capacitor bank if my energy meter is 48 kvr? tell me capacitor bank chossen formula?
What is non-minimum phase transfer function?
Why collecting electrode of ESP to be earthed
How to find ampere on ht side for selection of cable size ???
what is ramping rate of generator
What are the common sources of energy?
Why r u using pf panel. what the uses
How to justify this statement ??? "Capacitors in series provide less capacitance but higher voltage breakdown rating for the combination"
what are factors comes under relay setting (distance relay 7sa52) under OPEN DELTA VTs connection??
What if the difference beween internal and exrteranal LBB?
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
Is there any specialised book to refer about fault level calculation both in MV and LV side??
internally connection of photvoltic module
