In APFC panel, Why on dealy timer is used in Capacitor
controlling circuit?
- 1 Answers
- 8509 Views
- I also Faced
- E-Mail Answers
Answer Posted / vasudevan
In APFC panel delay timer is used to add the capacitors in
steps. Based on the reactive power factor and export power
factor requirement, capacitors are added as per the time
delay.
| Is This Answer Correct ? | 12 Yes | 3 No |
Post New Answer View All Answers
Please sent me some previous year question papers of BSNL-JTO telecom and RRB in ELectrical Engineering to varshashahi@yahoo.com
Why we find the sensitivity for the CT's to check?
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
How will you utilise electrical power? You can start from the generating station.
whatare the disadvantages occur,if the form factor of transmission will not be equal to 1.11
which type of effect of turbine and generator reverse power protection ?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
how the B-H loop obtain under the static condition
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
We have 750KVA DG set, we want to introduce REF relay with 1250/1A,CL PS,Current transformers.The lead distance of 2.5mm copper flexible cable from CT to relay is around 5mtrs.We would like to know the knee point votage(VK) & IM calculion for CT's
(In MEP services) HVAC in AC Plant room what else can we provide if the chiller is not considered?
what is LSR?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
how to select rating of HT Panel
