Answer Posted / arun mathew
General losses other than the main copper losses and iron
losses are collectively called stray losses.
stray losses include friction losses, windage losses. and
harmonic losses and is very difficult to measure
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
Why AC current leads voltage in capacitor and how?
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
hi guys please tell me the procedure for mesuring the coil resistance of 3ph induction motor?
Could the power factor on electrical system can affect the registration of the kwhr meter or the CT/PT?
Why is the frequency not changed during transformation of electrical energy in a transformer?
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
How Can You Relate Power Engineering With Electrical Engineering?
what is vtg limit of earth and neutral at transformer side?
what is meant by 2 within a star in a voltmeter dial?
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
what is counter poise conductors
what is the difference between the characteristics of two different phase bushing of any transformer
1.what is mean by 8/20 micro sec waveshape
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
