what is the diffrence between mmwc and kg/cm2 for pressure
measurment when we are using mmwc and when kg/cm2 and why?????
?? what is the reason
- 19 Answers
- 195665 Views
- Ecoboard, Jindal, Sepco, I also Faced
- E-Mail Answers
Answer Posted / vaibhav v t
10000 mmwc equals to 1 kg/cm2.
For low ranges pressure is mentioned in MMWC otherwise in
any other pressure units.
| Is This Answer Correct ? | 208 Yes | 29 No |
Post New Answer View All Answers
how many types of viberation transmitter and how to calibrate and where use of vibration transmitter
define feed forward control loop with example and drawing?
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
Explain bernoulli’s theorem.
How to decrease opening & closing time of on/off valve?
what is interface level measurement.who can calibrate interface level measurement transmitter online
i need some objective type questions in instrumentation
Explain the mechanism behind the turbine meter.
How to calibration coriolis flow meter?
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
Name different parts of a pressure gauge.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Please tell me details about Sox,Nox,SWAS analyser????
