Interested to Buy Any Domain ? << Click Here >> for more details...
when we megger is not damaged when we are measuring very
low resistance? high d.c. voltage is produced in megger so
according to i=V/R. current will be high so what is the
reason ?
- 1 Answers
- 4012 Views
- I also Faced
- E-Mail Answers
Answer Posted / vasanth
duu to the low resistance high current passed through
current coil
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
Why is a plain induction motor unsuitable for wide speed control?
how can we save enegry by using VFD for Resiprocating Air compressor which is having more unloading running hours
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
How to select the proper VSD to operate high inertial load
What is difference between isolator and circuit breaker?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
Hi My dear all Friends, There is a question regarding HVAC Engineering and widely used in Power Projects. Question- What is the diffrence Between REF, SEF and Differential Protection....???? Where REF - Restricted Earth Fault SEF - Senstive Earth Fault.
Any one can explaination about calibration with rotating sub standards?
what is doid
What do you mean by turns ratio of instrument transformer?
which book to refer in electrical engineering for iocl exam & which book for general english.
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
What are the disadvantages of thermal power plant?
Explain the difference between verilog task and verilog function?
