What is plugging as applied to an induction motor?
Answer Posted / sunil guru
PLUGGING ----- can be applied only for 3 ph. induction motor.
in this phenomenon motor running at full speed can be stopped (braking)by reversing the polarity of any 2 ph. out of any 3 ph.(R,Y,B).......
so that the rotating magnetic field is produced in opposite direction thus the torque produced act in opposite to the previous motion and the motor can be stopped......
but the disadvantage is that when the motor attains the zero speed the phase should be again interchanged to protect the motor from moving in opposite direction (extra provisions should be made for that.......)
for any disagreement mail me at parmar20072008@yahoo.com
| Is This Answer Correct ? | 33 Yes | 6 No |
Post New Answer View All Answers
hi friends ,iam working as genset AVR service engineer in electrical field from past 2 yrs throughout india . i plan to shift in some other job without travelling in same field because i con't travel,i dont know what i do for that so please guide me what job is suited for me,how i can serch the job please anybody helpme iam totally confused
How much no load current of synchronous motor
what is the function of capacitor duty contactor in an capacitor panel???
TCS IS IT COMPANY THEN WHY DO THEY NEED ELECTRICAL &ELECTRONICS ENGINEERS?
Define delay time.
Power Factor Correction Panel (Manual & Automatic)
How DC earth leakage currents can be reduced ?
Is a 300w induction motor used in a food processor as powerful as a 1000w DC motor.
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
what is transient enclosure vltage , very fast transients, very fast transient over voltages
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
1sq mm dc powr cable can carry how much dc currnt
What is a dominant pole?
what is the transformer turn ratio formula and give some examples?
what is the difference between Central Battery System and UPS in applications and uses? and why UPS suitable for Computers and central battery for emergency lighting?