Interested to Buy Any Domain ? << Click Here >> for more details...
dear friends pls tell me how temperature compensations are
done in bourdoun tube of pressure guages
thankx
- 1 Answers
- 4511 Views
- I also Faced
- E-Mail Answers
Answer Posted / kalpesh
Compensation is achieved by inserting a bimetallic bar into
the linkage between elastic element and the gauge movement.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
How is automatic reference junction compensation carried out in temperature recorders?
Emergency Shutdown Systems/ Plant Shutdown System.
What is the difference between modbus,fieldbus & profibus
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
steps for installing orifice plate?
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?
WHAT IS THE DIFF. BETWEEN SKIN TEMPERATURE AND PASSES TEMPERATURE..?
how works encoder in plc
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
how to calibrate 0- 150 psi presure gauge by dead weght tester
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
