Interested to Buy Any Domain ? << Click Here >> for more details...
what is the effect of leading power factor
- 3 Answers
- 9152 Views
- Aurobindo, R L Steels and Energy, I also Faced
- E-Mail Answers
Answer Posted / tareq harb
leading power factor means that the generators is sucking
reactive power instead of producing it, which leads the
alternator to overheat causing the windings insualtion to
melt which defenitely will damage the alternator.
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
Whats the minimum value for I.R. that can be allowed for HT & LT alternators for operation?
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
Wt is the function of reactive power? How it generates & consume though resultant is zero?
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
How does the phase sequence controller works, how it identifies the phases? confirm working principle
in electrical control panel. how can i choose the cable rating. (example - 11kw motor, 18-25A mpcb}
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
why dimmerstate always connected in star connection? what will happen if it connected in delta?
Sir pl provide 5 year sample paper for post junior engineer(electrical).I have currently applied for junior engineer (electrical) on RRB Ajmer
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
how much GROUND & NEUTRAL VOLT maintain in data center.
How to design pavement quality concrete by using C.R.C.P Method
