Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raja sekhar
b'coz u can know that the high voltage winding has low
current and when switch is tapped there is less possibility
of geetin arc
| Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
What are the special cables required for explosion proof wiring?
What is NGR . What is the purpose of 10 sec ,60 sec rating of NGR.
whatis the commertial spec. of distribution boards ?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
Explain the role of a car driver as one of a feedback mechanism.
i have applied for the post of RRB section engineering chennai board please send me previou papers and solved answer. my mail id jagarapusrinivas@gmail.com
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter
Is there any rule to select the voltage of motor based on KW rating? What is the rating above which lt motor becomes the HT motor?.
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
primery try cell?
how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?
How to calculate Ith (I thermal) for curent transformer
What do you mean by an instrument transformer?
Why a tesa lamp is glow between two phase?
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
