Interested to Buy Any Domain ? << Click Here >> for more details...
In the case of petrochemical area AC drive & AC motor is
used where the speed variation is required. Why they are
not Using DC drive & DC motors in such areas?
- 1 Answers
- 4353 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahavir jagdev
The petrochemical industry is susceptible to fire hazards. In DC motors the carbon brushes on the rotor create sparks, which can ignite the petro fumes or vapours. The AC motor speed can be controlled with electronic speed controllers (frequency or voltage type) thus the danger of fire is not there. Even in olden days the coal and other mines which had ignitable gases, had fire proof DC motors and switch gear, which was expensive.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
what is the value of combined earthing in general electrical circiut?
Which motor will you choose which can operate in both lagging as well as leading power factors?
Which type of transformer is used for lighting loads?
What is the meaning of dedicated earthing?
in 1-phase 230v,how in 3-phase 440v. in each phase in between 230v.
What is the working principle of CFL & T5 tube light & 40W tube light with electronic ballast?
PLS SEND THE RRB CHENNAI MODEL QUESTION PAPER my email id is ganesan98655@rediffmail.com
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
how we can calculate power factor in single phase & three phase ?thank u
why the neutral point in connnection oscillates?
Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?
what is negative d.c. voltage, why this voltage is used in base transciever station.
what is meant by re-rolling motor? how it differs from standard motor?
What does a Bode plot tell you?
