Interested to Buy Any Domain ? << Click Here >> for more details...
what is lead lag compensator and for wat v using that???
- 3 Answers
- 13461 Views
- I also Faced
- E-Mail Answers
Answer Posted / biswarup das
A lead-lag compensator is a component in a control system
that improves undesirable frequency response in a feedback
and control system. It is a fundamental building block in
classical control theory.
We are using it in varied discipline such as robotics,
satellite control, automobile diagnostics, laser frequency
stabilization and many more. It can also be used in digital
control.
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
Explain the difference between plc and cnc?
Calibration of controller (pneumatic)
in mass flow meter what is drive friquancy ?
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
what is intrinscily safe system and where we use?
how to measure oxygen which methods are using?
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
what is the difference between -24 : +24 & 0:24 and where it use?
what are the diff. in servo and regulatory control?
I want to apply for the universities in US,but i got the GRE score of (650+300=950)TOEFL 69/120.Is this score sufficient for applying universities please i am married i need to go to US because my husband didn't get H1 yet.please send me suggestion
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
Describe a time when you anticipated potential problems and developed preventive measures.
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
Explain bernoulli’s theorem.
