Interested to Buy Any Domain ? << Click Here >> for more details...
1. How many output signals do wew have in process control?
2. Could you write down the names of the pre-commissioning
and commissioning stage test instruments and explain them
(more than 5 items)?
3. What is the first step to commission a transmitter on
service?
4. What is RTD?
5. Find the output value in MA of a temperature transmitter
(RTD Type) at 120degree celius?
6. What is the O/P signal of a pneumatic transmitter?
7. What is the O/P signal of an elctronic transmitter?
8. What is the close loop and open loon?
- 4 Answers
- 10753 Views
- I also Faced
- E-Mail Answers
Answer Posted / biswarup das
Answer of Ques No.5)) Transmitter(Tx) o/p depends on
calibration range. If the Tx is calibrated in the range
0-120degC. Then it will show 20ma when the actual
temperature would be 120degC.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
How to calibrate an pressure gauge with yantrika test bench?
what are the use of belew gear in general ??
what does it mean an active front end in vfd plz explain it briefly
How to erection of DCS Panel at site step by step
Isometric drawings are generated during _________________ phase of a project
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
I am manjunath having exp in maintenance of chemical plants,know i want to do a design course INTOOLS,after doing design course can we get jobs in design field.sinve i dont have design exp..
Describe the functions of the Operator Interface including the considerations related to alarming and display layout/configuration/layers.
why we are using drum level control valve air to close?
How many ohms are required for proper earthing?
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
what is wave length were using ?
how to calibrate load cell
