Interested to Buy Any Domain ? << Click Here >> for more details...
what should be the value of proper neutral earthing
resistance?
- 3 Answers
- 8114 Views
- ABC, I also Faced
- E-Mail Answers
Answer Posted / mahesh sali
for solid earthing it will come around - 5 ohms
for resistive earthing the value being 1 to 2 ohms
for reactance earthing the above value will come down
around , it will be les than 1 ohm ,
thank u
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
How does a television work?
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
I need the recommended size for a 3 phase transformer at 13.8 KV Primary and connected loads of 3000 kVA at 4200 volts and 2375 kVA @ 480 volts AC.
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
i have interview in Pepsi company what type of question will ask please send the question and answeer
What is the need of generator relay panel
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
where rlc series ckt used?
What type of DC motor would you see for a lift?
What is the numerical quantity of sqcm?
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
what is the correct format to create a resume for interview??
